Assembling The Nebuliser - FLAEM NebulFlaem 4.0 Bedienungsanleitung

• Do not put any objects in the air vents.
• Repairs, including the replacement of the supply cord, are to be carried out by FLAEM authorised personnel only, by
complying with the information provided by the manufacturer.
• The average expected duration for the compressor series are: F400: 400 hours, F700: 700 hours, F1000: 1000 hours,
F2000: 2000 hours.
• WARNING: Do not modify this device without authorisation from the manufacturer.
• The Manufacturer, the Vendor and the Importer shall be held responsible for safety, reliability and performance only
if: a) the device is used in compliance with the instructions for use b) the wiring where the device is being used is in
compliance with safety regulations and current laws.
• Interactions: the materials used in contact with medication have been tested with a vast range of medications.
However, in view of the variety and continuous evolution of pharmaceuticals, interactions cannot be ruled out. We
recommend using the medication as soon as possible once it has been opened and preventing prolonged exposure
in the nebulizer cup.
• The manufacturer must be contacted about any problems and/or unexpected events concerning operation and for
any clarifications on use, maintenance/cleaning.
• Interactions: The materials used in the medical device are biocompatible in accordance with the provisions of
Directive 93/42 EC and subsequent amendments. However, the possibility of occurrence of allergic reactions cannot
be entirely excluded.
• The amount of time required between preservation conditions and use is approximately 2 hours.
Benefits of BioCote protection
The enclosure of NebulFlaem 4.0 are made of ABS mixed with antimicrobial additive BioCote®, which makes the
surfaces protected 24 hours a day and permanently provides antibacterial, antifungal and antiviral properties. Store
accessories in a more secure environment.

ASSEMBLING THE NEBULISER

Follow the assembly instructions below.
1. Assemble the nozzle (C1.3) on the upper part (C1.2).
C1.3
2. Place the valve (C1.1b) with the flat side down onto the particle size regulator (C1.1a) by aligning the hole with the
position ribs, then screw the selector (C1.1c) onto the threaded pin of the regulator all the way down. Rotate the as-
sembled regulator to make sure that it turns freely and that the selector moves up and down between positions.
C1.1b
C1.1a
C1.2
C1.2
C1.3
C1.1c
C1.1a +
C1.1b
2