Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Special accessories
Replacing the brush
Putting out of use
Special accessories
30
The roller brush is very simple to replace!
• Unscrew the bolt (see arrow – illustration on the left).
• The complete brush holder and brush can then be removed.
• When fitting the brush, make sure that the centring pins are properly engaged in it.
• When the brush is in the correct position, secure the brush holder with the above-
mentioned bolt.
Empty the fresh water and dirt water tanks as described.
• Tilt the automat backwards and flush it with clean water. Rinse out the dirt water
tank and the pipes with clear water. You can use the remaining clean water and
the hose (see "Emptying the fresh water tank" above").
• When you have finished cleaning the carpet, clean the brush tunnel. This is easier
if you remove the brush first (see "Replacing the brush"). Clean the underside of
the machine with a damp cloth.
• Relieve the pressure on the brush by pressing down the red lever on the side
(see "Work break and work finish").
• Disconnect the power plug.
• Upholstery Kit with hand tool
• Floor nozzle
Werbung
Kapitel
Inhaltsverzeichnis
