Operating; General Notes; Transporting The Appliance; Filling The Fresh Water Tank - Nilco SE-BA T 490 Bedienungsanleitung

Operating

Operating

General notes

Transporting the appliance

Filling the fresh water tank

Electrical connection

cable tensioner
mains cable
28
The appliance is suitable for cleaning all piled carpeting, cemented, stretched and
loose-laid fitted carpets with synthetic or woven backings.
Using warm water (max. 50 °C) improves the cleaning effect and facilitates the re-
moval of any oily or greasy contamination.
ATTENTION!
Care should be taken when cleaning fitted carpets with a jute backing. If such car-
peting is wetted excessively, it may shrink and become discoloured.
Before using the SE 490 it is best to vacuum-clean the carpeting.
Very dirty spots should first be sprayed with an up to 3% solution of carpet cleaner.
Allow approximately five minutes to react.
The appliance must be lifted with the handles when it is carried over a threshold. It is
easy to transport on account of its large wheels (e.g. upstairs).
ATTENTION!
Only use non-foaming cleaning agents that are suitable for use with carpet extrac-
tion machines.
Damage caused to the suction motor by foam will invalidate the warranty.
• Open up the cover of the fresh water tank.
• Fill the tank with water (max. 32 l/max. 50 °C).
• Add the recommended amount of cleaning agent as specified by the chemical
manufacturer.
• Close the cover again.
• Take care that the machine is only be connected to a mains power supply that
matches the voltage stated on the rating plate.
• Connect the mains cable with the extension cable and place it in the cable ten-
sioner on the right side of the push handle (see illustration on the left)
• Connect the plug of the extension cable to an earthed socket.
WARNING!
If an extension cable is used, it must always be completely unwound from the drum.
Make sure it has an adequate cross-section, or a short-circuit may result from the
cable being overheated ("scorching")
leads up to 10 m: wire cross-section 1,5 mm
leads up to 30 m: wire cross-section 2,5 mm
2
,
2
.