Troubleshooting - Beem Espresso Perfect II Ultimate 20bar Bedienungsanleitung

EN
7. Let the descaling solution take effect for a little while.
8. After around 30 minutes, move the selector switch to the
of the solution to run through.
9. Rinse the water tank thoroughly and to rinse the device allow two tankfuls of clear water to
run through it.
10. Rinse all detachable parts thoroughly with clear water. The device is now descaled and ready
to be used again.
Storage
Disconnect the device from the mains power when you are not going to use it for a prolonged
period. Clean the device again if necessary (see the "Cleaning and Care" chapter) and let it dry
completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem your-
self. If the problem cannot be solved with the steps that are listed, contact the customer service
department.
Do not attempt to repair a electrical device yourself!
Problem
The device cannot
be switched on. / The
operating lamp (17)
does not light up.
The fuse in the fuse
box is triggered.
03260_03270_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 34 03260_03270_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 34
Possible cause
The mains plug is not inserted
correctly in the socket.
The plug socket is defective.
There is no mains voltage.
The On / Off switch (16) has not
been pressed.
Too many devices connected to
the same circuit.
position again and allow the rest
Fix
Correct the fi t of the mains plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Press the On / Off switch to
switch on the device.
Reduce the number of devices in
the circuit.
34
22.07.2021 11:31:01 22.07.2021 11:31:01