Troubleshooting - Beem 03428 Bedienungsanleitung

39

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The control panel (3)
does not light up /
the device cannot be
switched on.
The fuse in the fuse
box is triggered.
Water runs out of the
device.
A function has
been selected, but
the device beeps
constantly and the
red indicator light (18)
fl ashes. The control
panel does not light
up.
03428_DE-EN-FR-NL_A5_V3.indb 39 03428_DE-EN-FR-NL_A5_V3.indb 39
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
No mains voltage is present.
The control panel lighting is
defective.
Too many devices connected
to the same circuit.
No error can be identifi ed.
There is too much water in the
water tank (2).
The water tank is not placed
in its mount correctly.
There is no water in the water
tank.
Fix
Insert the mains plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Contact our customer service
department.
Reduce the number of
devices in the circuit.
Contact our customer service
department.
Do not overfi ll the water tank!
Correct the fi t.
1. Detach the water tank from
the device and fi ll it with
water (see the "Handling
and Operation" chapter |
"Filling the Water Tank").
2. Place a cup underneath.
3. Then press any button.
Some water will run through
the water system into the
cup. The device will stop
beeping, the red indicator
light goes out and the
device can be restarted.
4. Select the function you
want again.
12.01.2018 11:24:46 12.01.2018 11:24:46
EN