Commencing Operation - Beurer ELLE MPE 60 Gebrauchsanleitung

– Never immerse the instrument in water or other liquids.
– If the instrument has dropped into water, unplug the plug-in power unit immediately.
– Ensure your hands are dry before handling either the instrument or the plug-in power unit.
– Do not pull on the power cord or instrument to unplug the plug-in power unit from the socket
outlet.
– The plug-in power unit must be operated only from a power supply as specified on it.
– If the power supply is damaged, don't use the adaptor anymore!
– This device is not intended for use by persons (including children) with restricted physical,
sensory or mental capabilities and/or by persons lacking the required understanding of the
equipment and how it is used, unless they are supervised by a person who is responsible for
their safety or they are given instructions on how to use the device.
– Children should be supervised to ensure that they do not use the device as a toy.
– For reasons of hygiene, the device should only be used on one person.

2. Commencing operation

2.1 Information concerning the instrument
This manicure and pedicure device comes with high-quality attachments. The supplied 9 attach-
ments are made with durable sapphire coating / polishing felt. Together with the continuously
adjustable speed regulation and right/left rotation, professional foot and nail care at the standard
of a pedicurist is possible.
All the attachments can be easily integrated into the storage pouch of the MPE 60.
2.2 Power supply
To ensure adequate power at all times for good and powerful treatment of the feet and nails, this
instrument is provided with a permanently attached power unit.
After use, before cleaning and changing any accessory parts, the power unit should al-
ways be disconnected.
Ensure that the sliding switch on the device is in the centre position (= off) before you
connect the device to a power supply.
3. Application
3.1 General
– This instrument is intended only for the treatment of hands (manicure) and feet (pedicure).
– Select an attachment and push it onto the instrument spindle using a slight pressure. The
attachments can be heard to engage. To remove: pull the attachment and instrument apart in
the axial direction (straight).
– Switch on the instrument by sliding the slide switch to the left (anticlockwise running) or to the
right (clockwise running). The two buttons marked with plus (+) and minus (-) allow you to se-
lect the speed of rotation. Start every application at low speed and increase it only as required.
– All file and cutting attachments are coated with a sapphire grain. This guarantees extremely
long life and almost guarantees freedom from wear.
– Do not exert heavy pressure and always guide the attachments carefully over the surface to be
treated.
– Move the instrument under light pressure in circular movements slowly over the parts to be
treated.
– Note that the cutting attachments will have a reduced effect if the skin is softened or moist.
For this reason, do not carry out any pretreatment in a bath.
– Do not remove all the callus skin in order to retain the natural protection of the skin.
– Always ensure that the spindle can rotate freely. It must never be permanently jammed, other-
wise the instrument will become too hot and suffer damage.
– After every use, apply moisturizing cream to the parts treated.
8