Intended Use; Operation; Safety; Initial Use - Beurer HK 70 Gebrauchsanweisung

4. Intended use

IMPORTANT
• This heat pad is only designed to warm up the human body.

5. Operation

5.1 Safety

IMPORTANT
• The heat pad is fitted with a SAFETY SYSTEM. This sensor technology provides protection
against overheating across the entire surface of the heat pad with an automatic switch-off in the
event of a fault.

5.2 Initial use

IMPORTANT
• Ensure that the heat pad will not bunch up or become folded during use.
It is possible to position the plug-in coupling at either the bottom left or bottom right of the heat pad.
Please first check on which side the socket is closest. To change the position, open the zip fastening on the
rear, remove the moulded foam part, push the plug-in coupling from the outside through the cover to the
inside, and then guide the plug-in coupling back out through the other opening. Then re-insert the moulded
foam part and close the zip fastening.
Use at home or at work
• Fasten the heat pad to the backrest of the chair by opening the two hook-and-loop fastening bands at the
side (4) and connecting and closing them at the rear of the backrest.
• First, connect the mains part to the heating pad by inserting the plug-in coupling (5).
• Then insert the mains part (2) into the socket. The ON/OFF button with LED display (6) will flash briefly.
Use in cars
IMPORTANT
• Under no circumstances use the hook-and-loop fastening bands at the side of the heat pad to
attach it to the car seat! Doing so would impair the function of the side airbag!
• Therefore, please close the side fastening bands at the rear of the heat pad, so that they do
not interfere with anything and the hook-and-loop sections cannot damage the backrest. Once
closed, they should lie flat against the rear of the heat pad.
First attach the car fastening straps (7) to the car seat. Place the
car fastening strap on the seat surface so that the smoother side
is facing upwards.
Car seat
front
15