Attaching And Removing The Grass Collector (10); Moving The Appliance On The Grass (11); Maintenance And Care - AL-KO COMBI-CARE 36 E comfort Betriebsanleitung

Maintenance and care

CAUTION!
Danger of lacerations
There is a danger of lacer-
ations when reaching into
the blade system while it is
running on.
■
Wait until the blade sys-
tem has stopped.
6.6 Attaching and removing the grass
collector (10)
The appliance can be operated with and without
grass collector.
Attaching the grass collector
1. Raise the impact flap (10/1) (pos. a).
2. Attach the grass collector (10/2) in the hold-
ers (pos. b) from behind.
3. Release the impact flap.
Removing and emptying the grass collector
1. Stop the appliance and wait until the blade
system has stopped.
2. Raise the impact flap (10/1).
3. Lift the grass collector (10/2) out of the hold-
ers and take off to the rear.
4. Empty the grass collector.
5. Attach the grass collector (see above).
6.7 Moving the appliance on the grass (11)
Guide the appliance (11/1) over the grass (as
shown in the image) in such a way to avoid dam-
aging the mains cable (11/2). Heed the safety in-
structions (see chapter 3 "Safety instructions",
page 21).
■
Watch out for objects in the grass and re-
move them from the working area.
■
Guide the mains cable by hand.
■
Only control the appliance by the handlebar.
■
Move the appliance at walking speed.
■
Always move the appliance across the slope.
441970_b
All manuals and user guides at all-guides.com
■
If the motor suddenly stops: The motor circuit
breaker has triggered due to an overload.
Wait a few minutes and then attempt to start
the motor again.
■
In the following cases, visit the customer ser-
vice workshop:
■
Motor no longer starts.
■
Appliance has moved onto an obstruc-
tion.
■
Appliance vibrates and does not run
smoothly.
■
The blades of the scarifier roller or steel
spring prongs of the aeration roller are
bent.
7 MAINTENANCE AND CARE
CAUTION!
Danger of lacerations
There is danger of lacera-
tions when reaching into
the blade system while it is
running on or the stopped
blade system.
■
Stop the appliance and
wait until the blade sys-
tem has stopped.
■
Disconnect the mains
plug to power down the
appliance.
■
Wear protective gloves.
25