Shutting Off The Engine; Engaging The Scarifier - Toro 54610 Bedienungsanleitung

Figure 13
8. After the engine starts, gradually move the
choke lever back to the O
engine stalls or hesitates, move the choke back
to the O position again until the engine warms
N
up, then move it to the O

Shutting Off the Engine

To shut off the engine, release the blade-control bar
and move the transport lever all the way back toward
you into the transport position
g348516
position. If the
FF
position.
FF
(Figure 10).

Engaging the Scarifier

When the scarifier engine is turned on, the roller
begins to rotate.
Slowly move the transport lever all the way forward to
lower the roller into the ground
Note:
If you have the blade reel shaft installed and
the scarifier does not penetrate the ground at the
desired depth, adjust the max depth of cut; refer to
Adjusting the Maximum Depth of Cut (page
1. Transport lever in the O
When you are finished scarifying, move the transport
lever all the way back toward you into the transport
position and release the blade-control bar to shut off
the machine.
14
(Figure 14).
10).
Figure 14
position
PERATING
g340496