Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Crank bracket
2. Bolt
9.
Install the new traction-cable bracket on the
crank bracket using the previously removed bolt
and nut.
10.
Hook the traction cable on the new traction-cable
bracket as shown in
Note:
Ensure that the traction cable is oriented
as shown in
Figure
1. New traction-cable bracket 2. Traction cable
Installing the Traction Rod
1.
Insert the new traction rod through the rear of
the machine
(Figure
2.
Connect the one end of the rod to the new
traction-cable bracket using a bolt and nut
included with the kit as shown in
Figure 6
3. Nut
4. Existing traction-cable
bracket
Figure
7.
7.
Figure 7
8).
Figure 8
Figure
g340089
1. Bolt
2. Traction rod
3.
Connect the other end of the rod to the new
traction plate using a bolt and nut included with
this kit
g340090
Completing the Installation
1.
Hook spring the was removed in Step
Installing the Traction Plate and Bracket (page
1)
on the new traction plate.
2.
Install the belt cover on the machine using the 2
corresponding screws.
3.
Install the spark plug wire.
4.
Check the operation of the traction cable and
adjust it if needed; refer to
Adjusting the Traction Cable (page
g340091
9.
3
Figure 9
3. Nut
(Figure
10).
Figure 10
Checking and
g340092
g340093
3
of
4).
Werbung
Inhaltsverzeichnis
