Setup; Assembling The Handle - Toro 54610 Bedienungsanleitung

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1

Assembling the Handle

Parts needed for this procedure:
2 Carriage bolt
4 Lock knob
2 Curved washer
2 Curved-head bolt
Procedure
WARNING
Assembling and unfolding the handle
improperly can damage the cables, causing
an unsafe operating condition.
• Do not damage the cables when unfolding
the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Install the lower handle over the post on the
lower handle bracket and position the lower
handle for desired handle height
2. Secure each side of the lower handle to the
machine using a carriage bolt and a lock knob.
Tighten the lower handlebar knobs.
1. Lock knob
2. Carriage bolt
3.
(Figure 3).
1. Curved-head bolt
2. Curved washer
4.
4
Figure 3
Shown installed at highest handle height
Install each side of the upper handle to the lower
handle using a curved washer, curved head bolt,
and a lock knob (Figure
Figure 4
Secure the cables that extend from the upper
handle to the lower handle using the cable
clamps.
g340201
3. Post on lower handle
bracket
4).
g340202
3. Lock knob