After Operation; After Operation Safety; Cleaning Under The Machine - Toro 54610 Bedienungsanleitung

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, wait for all moving
parts to stop, allow the machine to cool, and
disconnect the spark plug wire from the spark plug
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Prior to hauling, move the transport lever into the
transport position.
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.

Cleaning under the Machine

Service Interval: After each use
For best results, clean under the machine soon after
you have completed operating the machine.
1. Shut off the engine, wait for all moving parts to
stop, and allow the machine to cool.
2. Disconnect the spark-plug wire from the spark
plug; refer to Preparing for Maintenance (page
18).
3. Raise the machine to its highest depth-of-cut
setting.
4. Move the machine onto a paved level surface.
5. Holding the handle, tilt the machine up so the
bottom of the deck is accessible
6. Spray a stream of water under the deck
16).
Important:
Do not spray the engine with
water; water can damage the engine or
contaminate the fuel system.
Figure 16
7.
8.
(Figure 16).
(Figure
g345240
16
When no more debris come out, lower the
machine, stop the water, and move the machine
to a dry area.
Connect the spark plug wire and run the engine
for a few minutes to dry the underside of the
machine.