Assembling The Blower - Toro UltraPlus 51558 Bedienungsanleitung

Setup
1

Assembling the Blower

Parts needed for this procedure:
1 Blower tube
1 Inlet cover
Procedure
Install the blower tube and the bottom inlet cover.
Important:
The motor should not run unless the bottom
inlet cover is locked in place.
Note:
If the motor runs without the bottom inlet cover in place,
do not use the appliance. Return it to an Authorized Service
Dealer.
2
Converting from Blower to
Vacuum
Parts needed for this procedure:
1 Vacuum tube
1 Vacuum bag
Procedure
WARNING
The impeller rotates for a few seconds after you turn
off the appliance and can cut or injure fingers.
Do not remove the bottom inlet cover when the motor
is running or when the appliance is plugged into a
power outlet.
1. Remove the bottom inlet cover and the blower tube.
2. Install the vacuum tube and secure it with the supplied
fastener.
g025391
Important:
vacuum tube is locked in place.
Note:
If the motor runs without the vacuum tube in place,
do not use the appliance. Return it to an Authorized Service
Dealer.
Note:
You may need to push the connector firmly to
ensure that it seats all the way into the vacuum tube.
4
The motor should not run unless the
g027307