Troubleshooting - Toro 54610 Bedienungsanleitung

Troubleshooting

Problem
The engine does not start.
The engine runs rough.
The scarifier is hard to push.
The discharge chute becomes blocked.
The machine vibrates or makes unusual
noises.
Unsatisfactory scarifying results.
Possible Cause
1. The engine is under load.
2. The fuel tank is empty.
3. The choke is open.
4. The throttle is not in the FAST position.
5. The spark plug wire is loose or
disconnected.
6. The spark plug is loose.
7. The spark plug gap is incorrect.
8. The spark plug is dirty or damaged.
1. The choke is closed.
2. The air filter is clogged.
3. There is water or contaminants in the
fuel.
4. The spark plugs are worn or have
buildup on the electrodes.
1. The depth of cut is too low.
2. The wheels are damaged.
1. The depth of cut is too low.
2. The grass bag is full.
3. There is no airflow through the grass
bag.
1. Hardware is loose.
2. The machine is damaged.
1. Max depth of cut is set too high.
2. Cutting blades are worn or damaged.
23
Corrective Action
1. Ensure that the transport lever is in the
transport position so that the scarifier
roller is not contacting the ground
before starting.
2. Fill the tank with fresh fuel.
3. Close the choke when starting a cold
engine.
4. Move the throttle to the FAST position.
5. Ensure that the spark plug wire is clean
and completely connected.
6. Tighten the spark plug as necessary
per the engine owner's manual.
7. Check the electrode gap and correct
as necessary per the engine owner's
manual.
8. Clean or replace the spark plug.
1. Open the choke.
2. Clean or replace the air filter.
3. Drain the fuel tank and fill it with fresh
fuel.
4. Check the electrode gap and clean or
replace the spark plug.
1. Raise the max depth of cut and make
multiple passes.
2. Contact your Authorized Service
Dealer.
1. Raise the max depth of cut and make
multiple passes.
2. Empty the grass bag.
3. Empty and clean the grass bag.
1. Inspect for loose hardware and tighten
as necessary.
2. Contact your Authorized Service
Dealer for repairs.
1. Lower the max depth of cut.
2. Have them replaced; contact your
Authorized Service Dealer.