Preparing The Machine; Removing The Rear Wheels - Toro 145-5821 Bedienungsanleitung

Trailing Shield Kit
Model No. 145-5821
Installation
Important:
You will need a torque wrench to install the trailing shield and wheels properly. If you do not
have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service
Dealer. Visit Toro.com/locator to find an Authorized Service Dealer.
1

Preparing the Machine

No Parts Required
Procedure
1. Move the machine to a level surface.
2. Shut off the machine.
3. Wait for all moving parts to stop.
4. Remove the electric-start button (if equipped).
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420

Removing the Rear Wheels

No Parts Required
Procedure
Register at www.Toro.com.
2
1. Remove the bolts that secure the rear wheel to
the machine (Figure
Set aside the bolts for later installation.
Figure 1
1. Wheel
2. Remove the rear wheels from the machine
(Figure 1).
Set aside the wheels for later installation.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3449-741 Rev A
Installation Instructions
1).
2. Bolt
*3449-741*
g369899