Transporting; Storing; Cleaning; Maintenance And Repairs - Stihl AL 101 Gebrauchsanleitung

English
6.3 LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7

Transporting

7.1 Transporting
► Disconnect the plug from the wall outlet.
► Remove the battery.
► Wind up the connecting cable and attach it to
the charger.
► Transporting the charger in a vehicle: Secure
the charger with lashing straps, belts or a net
to prevent it turning over and moving.
8

Storing

8.1 Storing the Charger
► Disconnect the mains plug from the power
supply.
► Remove the battery.
1
► Wind up the connecting cable and attach it to
the charger.
► Observe the following points when storing the
charger:
– Charger is out of the reach of children.
– The charger is clean and dry.
– Charger is in an enclosed space.
– Charger is stored separately, away from the
battery.
– The charger is not suspended from the con‐
necting cable or the holder (3) for the con‐
necting cable.
– Charger is in a temperature range between
+ 5°C and + 40°C.
9

Cleaning

9.1 Cleaning the Charger
► Disconnect the mains plug from the power
supply.
► Clean the charger with a damp cloth.
14
2
3
► Clean vents with a paintbrush.
► Clean the charger's electrical contacts with a
paintbrush or a soft brush.

10 Maintenance and Repairs

10.1 Servicing and Repairing the
Charger
The charger does not need servicing and it can‐
not be repaired.
► If the charger has a malfunction or is dam‐
aged: Replace the charger.
► If the connecting cable has a malfunction or is
damaged: Do not use the charger and have
the connecting cable replaced by a STIHL
servicing dealer.

11 Troubleshooting

11.1 Troubleshooting Charger
If the battery is not being charged and the LED
on the charger flashes red: There is no contact
between the charger and battery.
► Remove the battery.
► Clean contacts on charger.
► Fit the battery.
► If the battery is still not being charged and the
LED on the charger flashes red: Do not use
the charger and contact your STIHL servicing
dealer.
Malfunction in charger.

12 Specifications

12.1 STIHL AL 101 Charger
– Rated voltage: See rating plate
– Frequency: see rating plate
– Rated power: see rating plate
– Charging current: See rating plate
– Permissible temperature range for operation
and storage: + 5 °C to + 40 °C
For charging times, see www.stihl.com/charging-
times.
12.2 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
7 Transporting
0458-013-9901-A