Charging The Battery; Led On Charger; Transporting; Storing - Stihl AL 301 Gebrauchsanleitung

8 Transporting

1 2
c
b
a
► Check the following points when mounting the
charger on a wall:
– Suitable fixing materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b = at least 100 mm
– c = 100 mm
– d = 4.5 mm
– e = 9 mm
– f = 2.5 mm
7.2

Charging the Battery

The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, note the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts automatically when
the mains plug is plugged into a socket and the
battery is inserted into the charger. The charger
switches off automatically when the battery is
fully charged.
The battery and the charger warm up during
charging.
The charger has a built-in fan which may cut in
and out during the charging process.
2
4
1
► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
0458-010-9921-B
3
e
d
f
f
13.4. The
3
7
6
5
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery stop glowing: The battery (2) is fully
charged and can be taken out of the charger
(3)
► If the charger (3) is no longer required. Dis‐
connect the mains plug (6) from the wall outlet
(7).
7.3

LED on Charger

The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
8 Transporting
8.1 Transporting the Charger
► Disconnect the plug from the wall outlet.
► Remove the battery.
► Wind up the connecting cable and attach it to
the charger.
► Transporting the charger in a vehicle: Secure
the charger with lashing straps, belts or a net
to prevent it turning over and moving.
9

Storing

9.1

Storing the Charger

► Disconnect the mains plug from the wall
socket.
► Wind up the connecting cable and attach it to
the charger.
English
1
15