Charging Procedure; Alarms - Telwin MASTERCHARGE 370 Betriebsanleitung

5. CHARGING PROCEDURE

LED BAR
Fixed green
Green flashing
Flashing blue
Fixed blue
Fixed green

6. ALARMS

Charging station ready.
Vehicle disconnected.
Charging connector inserted in the vehicle socket.
Pass the card through the dedicated area to start the charging process.
Charging in progress.
To interrupt charging, pass the card again in the dedicated area.
Charging complete.
Charging connector disconnected from the vehicle socket.
Place the cable back on the specific cable winder.
FLASHING RED SEQUENCE
DESCRIPTION
The emergency
button was pressed.
Voltage too high.
Voltage too low.
Overcurrent.
Short circuit.
Short circuit on
control circuit.
- 6 -
CAUSE SOLUTION
Turn the switch
clockwise.
Check the power
supply voltage.
Check the power
supply voltage.
Remove the charging
connector from the
socket of the vehicle
and repeat the
charging procedure.
Remove the charging
connector from the
socket of the vehicle
and repeat the
charging procedure.
Remove the charging
connector from the
socket of the vehicle
and repeat the
charging procedure.