Safety Instructions; Technical Specifications; Description; Control And Connection Devices - Telwin MASTERCHARGE 370 Betriebsanleitung

1. SAFETY INSTRUCTIONS

• Hazardous voltages are present on the device and the
power lines which could cause death.
• The connections compartment should only be opened
by qualified staff.
• The charging station must be installed by a specialist
technician who is responsible for compliance with
standards and provisions in force.
• Use the device exclusively for applications compliant
with its intended use.
• Check insulation of the cables is not worn.
• Do not use adaptors or extensions of the charging
cable
• Maintenance interventions must only be carried out in
authorised centres.
• The device must be supervised when used with children
present.
ADDITIONAL PRECAUTIONS
During the charging
procedure, the cable
must not be strained.
The charging cable
must not be bent or
twisted.
Do not drive over the
charging cable or
connector with the
vehicle.
The charging cable
must be wound and
repositioned in a
compact manner.
- 4 -

2. TECHNICAL SPECIFICATIONS

The main data on use and performance of the charging station
is summarised on the rating plate and has the following
meaning:
Fig. A
1. Name of model.
2. Mains connection: voltage, frequency, current intensity
3. Reference standard
4. Manufacturer's name and address.
5. Serial number to identify the charging station (essential for
technical assistance, spare part requests, tracing of product
origin).
6. Protection rating of the casing.
7. CE symbol
8. Indication: read the instructions
9. Disposal instruction
NB: The rating plate shown is an example to explain the
meanings of the symbols and figures; the exact technical
specifications for the charging station should be taken directly
from the rating plate on the device. Further technical details
are found in the APPENDIX.

3. DESCRIPTION

This charging station is an ideal solution to create a safe
charging point for your electric car.
Main features:
• Provided completely assembled and tested for simple and
fast wall installation.
• Integrated vehicle side cable (5 metres), with the Type 2
connector.
• Continuous control of the charging process to guarantee
user and vehicle safety.

3.1 Control and connection devices

Fig. B
1. Emergency button: in an emergency situation, press the
switch to interrupt vehicle charging. To reset the switch,
turn it clockwise until the actuator lifts.
2. Led bar with 3 different colours:
a. Green: vehicle disconnected.
b. Blue: vehicle connected.
c. Red: Alarm.
3. Card sliding area: on passing the card, the process starts (or
stops) of vehicle charging.
4. Power cable input.
5. Charging cable.
6. Type 2 charging connector (IEC 62196-2).

3.2 Protection devices

1. Over and under voltage.
2. Overcurrent.
3. Short circuit.
4. Emergency button intervention.
5. Plug connection anomalies.

4. INSTALLATION

The installation operations can only be carried out by
adequately qualified people and who have read and
understood the instruction manual.
• Electrical installation to standard, in compliance with
legislation in force in the country of installation.
• Electrical installation according to safety standards and
legislation in force.
• The charge station must only be connected to a power