Packaging; Starting, Operation - WIKA SL-1 Betriebsanleitung

5. For your safety / 6. Packaging / 7. Starting, operation
Please make sure that the pressure transmitter is only used within the over-
!
„
load threshold limit all the time!
Observe the ambient and working conditions outlined in section 7 „Technical
Warning
„
data".
Ensure that the pressure transmitter is only operated in accordance with the provisions i.e. as
„
described in the following instructions.
Do not interfere with or change the pressure transmitter in any other way than described in
„
these operating instructions.
Remove the pressure transmitter from service and mark it to prevent it from being used again
„
accidentally, if it becomes damaged or unsafe for operation.
Take precautions with regard to remaining media in removed pressure transmitter. Remaining
„
media in the pressure port may be hazardous or toxic!
Have repairs performed by the manufacturer only.
„

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure transmitters
„
Inspect the pressure transmitter for possible damage during transportation. Should there
„
be any obvious damage, inform the transport company and WIKA without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing
„
installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.

7. Starting, operation

Required tools: wrench (flats 27), screw driver
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi SL-1
EN
5