FMS 1:6 Jimny Bedienungsanleitung Seite 6

EN
Instructions
After setting up, follow the instructions below to operate the system.
1、Power On
Follow the steps below to turn on the transmitter:
1. Check to make sure that that battery is fully charged and installed correctly.
2.Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
For safety always power on the transmitter before the receiver.
Note Operate with caution in order to avoid damage or injury.
Make sure that the throttle is at its lowest position and the switches are set to their up position.
Note
2、Binding(The transmitter and receiver have already been bound at the factory)
However if the receiver needs to be replaced or additional receivers bound follow these steps:
1.Turn on the transmitter while holding the bind button to enter bind mode. G.LED will start flashing quickly:
Once in bind mode release the bind button.
2.The receiver will enter bind mode atomically when powered on.
3.Once binding is successful the receiver' s LED will flash slowly and the transmitter' s LED will remain solid
after being rebooted.
Note: When binding, put the transmitter into bind mode first, then the receiver.
Applicable to the FS-G4P transmitter and the FR-R4P receiver. Different receivers have different
bind procedures. For more information visit the FMS website for manuals and other related
information.
Product information is updated regularly, please visit our website for more information.
3、 Stick Calibration(This function is used to set the neutral position for throttle and wheel)
Every transmitter is calibrated before leaving the factory, however if recalibration is required,please follow
these steps:
1.Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way forward,then turn on
the transmitter in calibration mode.
The R.LED and G.LED will flash twice.
2.Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
When calibration is completed the R.LED will be off.
3.Trigger calibration: Pull the trigger back then forward as far as it will go.
When calibration is completed the G.LED will be off.
4.Once calibration is complete press the bind key to save and exit.
05