FMS 1:6 Jimny Bedienungsanleitung Seite 5

EN
Getting Started
Before operation, install the battery and connect the system as instructed below.
Transmitter Battery Installation
Only use specified battery (X4 AA batteries).
Danger
Do not open, disassemble, or attempt to repair the battery.
Danger
Danger Do not crush/puncture the battery, or short the external contacts.
Do not expose to excessive heat or liquids.
Danger
Do not drop the battery or expose to strong shocks or vibrations.
Danger
Always store the battery in a cool, dry place.
Danger
Do not use the battery if damaged.
Danger
Battery Type: AA
Battery Installation:
1.Open the battery compartment cover.
2.Insert 4 fully-charged AA batteries into the compartment. Make sure that the battery makes good contact
with the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2v, the G.LED on the panel will flash slowly.
04