Silvercrest SBKO 4.0 A1 Bedienungsanleitung Und Serviceinformationen Seite 70

SilverCrest SBKO 4.0 A1
When there is an established connection, the LED (8)
flashes blue twice briefly about every 3 seconds. As
soon as the device is switched off or is out of range, the
headphones switch to standby mode (not connected)
and the LED (8) flashes blue once briefly every 3
seconds.
If you want to connect another device (smartphone or
media player) to the headphones, you must repeat the
pairing process as described previously.
As soon as the previously connected device comes
within range of the headphones, the connection is
established automatically. You may need to confirm the
connection on your device.
Connecting headphones
Bluetooth
You can connect the headphones to two Bluetooth
devices at the same time. Establish the connection to
your Bluetooth
previous section "Connecting headphones" for further
details.
Then activate the multiple connection mode by pressing
the ▸ll button (4) and the ▸▸l + button (5) at the
same time in standby mode (not connected) for at least
2 seconds until four signal tones are issued in an
ascending tone sequence.
You can deactivate the multiple connection mode by
pressing the
the same time in standby mode (not connected) for at
least 2 seconds until four signal tones are issued in a
descending tone sequence.
68 - English
®
devices
®
devices in sequence, please note the
▸ll button (4) and the
to two
-
l◂◂ button (3) at
®