Installing Built-In Version - Dometic SILENCIO HC302D Montage- Und Bedienungsanleitung

HC302D, HC502D
6.2 Installing freestanding version
Observe the following instructions when installing:
1. Install the refrigerator so that the warm air produced can easily flow away, either
upwards or to the sides.
2. Place the refrigerator at the chosen place.
3. Leave the refrigerator to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
6.3

Installing built-in version

!
CAUTION!
Ensure the shelf is adequate to carry the total weight of the refrigerator
and the contents to be stored.
Observe the following instructions when installing:
• Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the front, see fig. 3, page 4).
Key to fig. 3, page 4
No. Explanation
1 Cold intake air
2 Hot waste air
• Make sure that the refrigerator door is able to open at least 100°. Otherwise the
drawers cannot be used.
1. Check the dimensions of the refrigerator (fig. a, page 8 or fig. b, page 8).
2. Place the refrigerator according to fig. 4, page 4 or fig. 5, page 5.
3. Mount the refrigerator to the furniture by two screws through the fittings at the
bottom (fig. 6, page 5).
4. Leave the refrigerator to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
EN
Installing and connecting the refrigerator
17