HC302, HC502
6.2
Installing freestanding version
Observe the following instructions when installing:
• Install the refrigerator so that the warm air produced can easily flow away, either
upwards or to the sides.
• Leave the device to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
➤ Place the refrigerator at the chosen place.
6.3
Installing built-in version
Observe the following instructions when installing:
• Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the front, fig. 3, page 4).
Key to fig. 3, page 4
No.
Explanation
1
Cold intake air
2
Hot waste air
• Leave the device to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
• Make sure that the refrigerator door is able to open at least 100°. Otherwise the
drawers cannot be used.
➤ Mount the refrigerator to the furniture by two screws through the fittings at the
bottom (fig. 4, page 4).
EN
Installing and connecting the refrigerator
15