Installing Built-In Version - Dometic SILENCIO HC Serie Montage- Und Bedienungsanleitung

Installing and connecting the refrigerator
6.3

Installing built-in version

!
CAUTION! Health hazard
Ensure the shelf is adequate to carry the total weight of the refrigerator
and the contents to be stored.
Observe the following instructions when installing:
1. Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the front, see fig. 3, page 4).
Key to fig. 3, page 4
No. Explanation
1 Cold intake air
2 Hot waste air
2. Make sure that the refrigerator door is able to open at least 100°. Otherwise the
drawers cannot be used.
3. Check the dimensions of the refrigerator (fig. a, page 8 or fig. b, page 8).
4. Place the refrigerator according to fig. 4, page 4 or fig. 5, page 5.
5. Mount the refrigerator to the furniture by two screws through the fittings at the
bottom (fig. 6, page 5).
6. Leave the refrigerator to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
6.4 Connecting the refrigerator to the power supply
A
NOTICE! Damage hazard
• Connect the refrigerator to a separate circuit to prevent
malfunctioning due to problems with other electrical equipment.
Never connect the refrigerator to a single socket with other electrical
equipment by means of a multi-socket.
• UK only: The refrigerator is supplied with a plug fitted with 3 A fuse.
In case this fuse has to be to changed, a 3 A ASTA approved
(BS 1362) fuse must be used.
16
HC 302, HC502
EN