Focal DIMENSION Bedienungsanleitung Seite 28

DIMENSION
U s e r m a n u a l
Problem
No sound is coming from the
subwoofer connected to the
SUB LINE OUT output.
The CEC via the HDMI™
connections are not working
correctly.
The audio and the video are
not synchronised.
The remote control is not
working.
Your TV is equipped with
the Audio Return Channel
function but there's no sound
when Dimension's TV input is
selected.
Possible causes
The cable has not been
connected correctly or there's
a fault with the cable.
The "SUBWOOFER" selector
setting is positioned
incorrectly.
The subwoofer used is
set to OFF, Standby or is
malfunctioning.
The CEC command via
HDMI™ is deactivated on your
audio-video devices.
At least one of your devices is
not equipped with this control
function.
Your TV is not equipped with
an automatic synchronisation
function.
Dimension is not within reach
of your remote control or the
angle is too extreme.
The battery in your remote
control is low.
The Audio Return Channel
function on your TV is
deactivated.
The HDMI™ cable has not
been connected incorrectly or
a there's a fault
with the cable.
Possible solutions
Check the cable
is connected correctly.
Check that the
"SUBWOOFER" selector is
set to 12 - SUB LINE OUT.
Check your active subwoofer
is working correctly.
Enable this function on
the audio-video devices
connected to Dimension.
/
Use Dimension's manual
"SYNC" function.
The reach of the remote
control is approximately
7 metres. The maximum
angle is 20°.
Replace the battery.
Refer to your TV's user
manual and enable the
TV's Audio Return Channel
function.
Check connections are
correct. If the problem
persists, try another HDMI™
cable.
28
More
information
Page 24
Page 17
/
Page 25
/
Page 26
/
Page 10
Page 18
Page 18