Light Function; Troubleshooting - Focal DIMENSION Bedienungsanleitung

DIMENSION
U s e r m a n u a l
26
When the signals have been synchronised, exit the synchronisation mode by pressing the button on your remote
control again. Synchronisation adjustments vary depending on the input. You can adjust the synchronisation of the
audio and video differently for the various inputs, thus for your different devices.
Note: If you want to restore the programmed delay default (factory settings) or automatic synchronisation on HDMI™
In, press the button on the remote control or user interface until the bar display volume are all extinct.

8.9. light function

The user interface light is normally off. You can turn it on for a few seconds by pressing the "Light" button on your
remote control.

9. troubleshooting

Refer to the table below if you encounter any problems with Dimension. If the problem persists, or if none of the
solutions proposed solve the problem, turn Dimension off and contact your dealer or Focal's authorised After Sales
Service.