Werbung
6
Safety Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The shower system may only be used for bathing,
hygienic and body cleansing purposes.
6 The hot and cold supplies must be of equal pres-
sures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart®
(flow limiter) located behind the aerator can be
removed.
• Hansgrohe mixers can be used together with hydrauli-
cally and thermically controlled continuous flow heat-
ers if the flow pressure is at least 0,15 MPa.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 12 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
English
Symbol description
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 6
Adjustment
To adjust the hot water limiter on single lever
mixers, please see page 5. No adjustment
is necessary when using a continuous flow
water heater.
Do not use silicone containing acetic acid!
Dimensions (see page 9)
Flow diagram
(see page 9)
with EcoSmart®
without EcoSmart®
Spare parts (see page 10)
Special accessories
special tool (58085000) order as an extra
Installation putty order as an extra
Operation (see page 12)
Cleaning recommendation
(see enclosed brochure)
3
Werbung
