ADE M320000-01 Gebrauchsanweisung Seite 26

- Make sure to lay the power cord between the scale and mains connection so as to preclude a
strangulation hazard.
- Never move the scale back and forth at the place of use as this may cause damage to the load
cells.
- Operate the device only within the permissible ambient conditions.
- After starting up the scale (connect it to the power supply and turn on the main switch), the
scale must warm up for 15 minutes. Accuracy is only guaranteed after this time.
- Do not expose the scale to high temperatures, whether from neighbouring devices or direct
sunlight. The liquid crystal display may suffer damage.
- Use the scale at constant ambient temperatures and avoid using in draughts, otherwise the
measurement results could be falsified.
- After Storage under extreme conditions at least 60 min required until the scale has acclimated
and is ready for intended use.
- If possible, place the scale away from other devices or sources that generate electromagnetic
or other disturbances as these can falsify the measurement results.
- Use only approved accessories and peripherals. The use of unauthorised accessories or cables
will invalidate the classification of the scale as a medical device.
- Before cleaning the device, disconnect the mains adapter from the mains.
- Do not immerse the device in water or other liquids.
- If the scale will not be used for a long time, it should be cleaned and stored in a protective film.
The addition of a drying agent is desirable.
- Remove the batteries if you are not going to use the scale for a long time.
- If you have any problems with this device, such as setting up, maintaining or using, please
contact authorised customer support. Do not open or repair the device by yourself.
- Please report authorised customer support if any unexpected operation or events occur.
DO NOT use the scale:
- If the mains adapter is damaged;
- If the mains adapter is not working;
- If the battery compartment has an unnatural bulge;
- After long storage in a humid environment.
In such cases, please contact authorised customer support.
Page 26 of 24 M320000-01+02-210429-Rev004-UM-en