Power Supply; Handover; Maintenance; Specification - AEG GH 300-900 S Bedienung Und Installation

Installation – for qualified contractors

9.3 Power supply

WARNING Electrocution
Carry out all electrical connection and installation
work in accordance with relevant regulations.
Material losses
!
The specified voltage must match the mains voltage.
» Observe the type plate.
Material losses
!
This appliance is unsuitable for fixed electrical ca-
bles.
» Connect the appliance to a suitable socket.
Note
The power cable may only be replaced (for example
if damaged) by a qualified contractor authorised by
the manufacturer, using an original spare part.
The appliance is delivered fully wired. The following elec-
trical connections are permissible:
Connection to a freely accessible standard socket
with matching plug
Permanent connection to an appliance junction
box with earth conductor
9.3.1 Connection to a standard socket
» Plug the appliance into a standard socket.
Note
You can push excess cable back into the space be-
tween the rear panel and wall.
9.3.2 Permanent connection
WARNING Electrocution
In the case of a permanent connection, the appliance
must be able to be separated from the power supply
by an isolator that disconnects all poles with at least
3 mm contact separation.
Material losses
!
◦ Trim the power cable so it leads directly to the
appliance connection socket.
◦ Ensure that, after trimming the power cable,
the appliance can still be removed from the wall
without problem.
» Trim the power cable by cutting off the plug.
» Connect the power cable to a suitable socket.

10. Handover

» Explain the functions of the appliance to the user.
Draw special attention to the safety instructions.
» Hand over the operating and installation instructions
to the user.

11. Maintenance

The appliance contains no serviceable parts.
16

12. Specification

12.1 Dimensions and connections

a10 Appliance Height
a20 Appliance Width
a30 Appliance Depth

12.2 Minimum clearances

GH 300-900
X
X
≥100
a20
GH 300 GH 500 GH 700 GH 900
mm 600 600
mm 600 1000
mm 49 49
≥100
a30
600 600
1400 1800
49 49