AEG GH 300-900 S Bedienung Und Installation Seite 15

9.2.2 Retaining bracket
The appliance is supplied with a retaining bracket to pre-
vent the wall mounted appliance from moving or tilting.
Two mounting holes for the retaining bracket are already
pre-punched into the rear panel. These mounting holes
are each provided with a fixing screw for the retaining
bracket.
1 Pre-punched mounting hole
2 Retaining bracket
3 Fixing screw
◦ If you mount the appliance horizontally, attach the re-
taining bracket to the long edge of the appliance.
◦ If you mount the appliance vertically, attach the re-
taining bracket to the short edge of the appliance.
9.2.3 Wall mounting bracket installation
Note
Use the wall mounting bracket as a drilling template
when marking the fixing holes.
» Attach the wall mounting bracket to the wall
using one horizontal slot and one vertical slot.
Note
The screws and rawl plugs are not part of the stand-
ard delivery.
» Use appropriate fixing materials.
» Determine the position of the appliance. Mark the
centre of the top edge of the appliance on the wall.
» Starting from the centre of the top edge of the ap-
pliance, mark the fixing holes for the wall mounting
bracket on the wall.
» Drill the fixing holes for the wall mounting bracket.
» Secure the wall mounting bracket on the wall.
» Adjust the position of the wall mounting bracket until
it is horizontally level. The horizontal and vertical
slots in the wall mounting bracket enable alignment if
drilled holes are not completely accurate.
1
3
2
Installation – for qualified contractors
9.2.4 Fitting the retaining bracket
1
1 Retaining bracket
» Attach the retaining bracket to the rear panel using
the fixing screw provided.
2
1 Wall mounting bracket
2 Retaining bracket
Material losses
!
Ensure that the power cable is not pinched or dam-
aged when you hook in the appliance.
We recommend that you fully extend the power cable
before wall mounting.
» Hook the appliance centrally onto the wall mounting
bracket.
» Mark the fixing hole for the retaining bracket on the
wall.
» Lift the appliance off the wall mounting bracket.
» Drill the fixing hole for the retaining bracket.
9.2.5 Hooking the appliance into place
» Hook the appliance centrally onto the wall mounting
bracket.
» Lock the appliance in by securing the retaining
bracket to the wall.
1
15