Power Supply; Troubleshooting; Appliance Handover - AEG BHG 1000W Bedienung Und Installation

Installation - for contractors
Note
Note the alignment of the wall sleeves.
» Use screws to secure the wall sleeves.
» Secure the retainers to the rungs. Do not yet tighten
the retainers.
» Fit the wall mounting bracket. For this, observe the
slot position. The slot must point respectively up or
down.
» Assemble the appliance and wall mounting bracket.
» Insert and tighten the screws to secure the
appliance.
14
9.3 Fitting the bathrobe hooks
1
1 Bathrobe hook
2 Washer
3 Bathrobe hook backplate
» Fit the bathrobe hooks as shown.

10. Power supply

WARNING Electrocution
In wet rooms such as shower rooms and kitchens,
install the flush box at least 25 cm above the floor.
WARNING Electrocution
Never operate the appliance with an extension cable
or a multiple socket.
Material losses
!
Ensure the appliance can be separated from the
power supply by an isolator that disconnects all
poles with at least 3 mm contact separation. For this,
use contactors, mains isolators, fuses, etc. Installa-
tion with a permanent power cable is not permitted.
Material losses
!
Observe the type plate. The specified voltage must
match the mains voltage.
Note
Carry out all electrical connection and installation
work in accordance with national and regional reg-
ulations.
Note
Ensure a standard socket or junction box for a per-
manent power supply is installed at a distance of at
least 10 cm from the side of the appliance.

11. Troubleshooting

The power cable must only be replaced by a qualified
contractor using original spare parts.

12. Appliance handover

» Explain the functions of the appliance to the user.
» Draw special attention to the safety instructions.
» Pass on the operating and installation instructions to
the user.
2 3