Appliance Installation; Wall Mounting; Power Supply; Initial Start-Up - AEG NSH 65 Bedienung Und Installation

10. Appliance installation

10.1 Wall mounting

Material losses
!
Only mount the natural stone heater on a flat wall, as
otherwise cracks may develop in the natural stone
panel due to stresses. In the event of unevenness
in the mounting wall, level the surface before tigh-
tening the fixing screws.
Material losses
!
Do not tilt or tip the natural stone heater. Otherwise,
it may break.
Material losses
!
If the fixing screws are over-tightened, the rawl plugs
in the natural stone panel may over-rotate and be-
come loose.
» Measure dimensions a and b for the drill holes on the
natural stone heater.
» Based on the measurements, drill the holes in a wall
with sufficient load-bearing capacity. Maintain a saf-
ety margin of 100 mm on all sides (e.g. dimension b
+ 100 mm).
» Screw the hexagon screws far enough into the drill
holes that the natural stone heater can still be hoo-
ked over the screw heads with the open slots in the
wall mounting brackets.
» Hang the natural stone heater. Tighten the hexagon
screws. Relieve any stress by slightly loosening the
fixing screws in the natural stone panel. Then retigh-
ten the fixing screws.

10.2 Power supply

Material losses
!
Only shorten the power cable far enough to be able
to hang the natural stone heater without disconnec-
ting the power cable.
Only connect the natural stone heater to an alternating
voltage of 230 V / 50 Hz.
L
N
PE
N N L' L
NSH
Installation - for contractors

11. Initial start-up

Material losses
!
When heating up the natural stone heater for the first
time, observe a maximum heat-up time of 20 minu-
tes. Then let the panel cool down for at least 60 mi-
nutes.
» Perform this process one more time.
In the first two days of use, heat up the natural stone
heater step-by-step to the required room temperature.
This way, you avoid hairline cracks. If hairline cracks do
develop, these are harmless and do not impair the func-
tion or the safety of the natural stone heater.

12. Handover

» Explain the functions of the appliance to the user.
Draw special attention to the safety instructions.
» Hand over the operating and installation instructions
to the user.

13. Specification

13.1 Dimensions and connections

B
a

13.2 Minimum clearances

70
40
230 V
23 23
15