Kernau KGH 6434 T CI B Bedienungsanleitung Seite 41

TYPE OF
HOT PLATE
Gas hot plate
ATTENTION!!!
If the power supply cable is replaced, the installer should leave the ground wire (B) longer than the
phase conductors (fig. 19) and comply with the recommendations given in paragraph 8.
I
n case of failure or cut in the
cable, please move away from
the cable and do not touch it.
Moreover the device must be
unplugged and not switched
on. Call the nearest authorized
service center to fix the
problem.
In case of adaptation of the hob to another type of
gas, operate as described in the directions for the and
installation use and replace the label on the bottom with
the one provided in the spare bag.
SERVICING
CABLE TYPES AND SECTIONS
TECHNICAL DATA FOR THE
APPLIANCE GAS REGULATION
TYPE OF
CABLE
H05 RR-F
17
SINGLE - PHASE
POWER SUPPLY
Section 3 x 0.75 mm
2
FIG. 19