Kernau KGH 6434 T CI B Bedienungsanleitung Seite 35

4/A) FIXING THE HOT PLATE
INSTALLATION TYPE B:
The hot plate has a special seal which prevents liquid from infiltrating into the cabinet. Strictly comply with
the following instructions in order to correctly apply this seal:
- take off all the movable parts of the hob.
- Cut the seal in 4 parts of the necessary lenght to positionning it on the 4 edges of the crystal.
- Overturn the hot plate and correctly position seal "E" (fig. 11/A under the edge of the hot plate itself, so
that the outer side of the seal perfectly matches the outer perimetral edge of the crystal. The ends of the
strips must fit together without overlapping.
- Evenly and securely fix the seal to the crystal, pressing it in place with the fingers.
- Position the hob in the hole in the unit and fasten it in place using the appropriate screws "F" of the
fastening hooks "G" (see fig. 11).
- In order to avoid accidental touch with the overheating bottom of the hob, during the working, is
necessary to put a wooden insert, fixed by screws, at a minimum distance of 70 mm from the top (see
fig. 7).
Caution: Do not allow the glass (A) lay directly on the
work top. it is the metal bottom "carter" (B) that has
to be in touch with the work top (see fig. 11/B).
Mod.: 30 cm.
INSTALLATION TYPE: B
INSTALLATION
30 cm.
FIG. 11
11
FIG. 11/B
FIG. 11/A