Install Rain Gauge Funnel; Install Batteries; Sensor Array Installation - Bresser 7003200 Bedienungsanleitung

3.1.2

INSTALL RAIN GAUGE FUNNEL

Install the rain gauge funnel and rotate clockwise to lock the funnel to the sensor array.
3.1.3

INSTALL BATTERIES

Unscrew the battery door at bottom of unit. Insert the 3 AA batteries (non-rechargeable) according to the
+/- polarity indicated. The red LED indicator on the back of the sensor array will turn on, and then begin
flashing every 12 seconds.
NOTE:
We recommend using non-rechargeable Lithium AA batteries for cold weather climate, but normally Alkaline
batteries are sufficient for use in most weather condition.
3.1.4

SENSOR ARRAY INSTALLATION

MOUNTING KIT SET
1. Pole mounting stand x 1
4. screws x 4
7. screw x 1
Step 2
Lock
grooves
2. Mounting clamp x 1
5. Hex nuts x 4
8. Hex nut x 1
44
Step 1
3. Plastic pole x 1
6. Flat washers x 4