Check Radio System; Getting Started - Modster Vector SR48 Brushed Betriebsanleitung

Manual - Vector SR48 Brushed
Boat Battery Installation
1. Rotate the hatch of the hull cover by clockwise to unlock the hatch.
2. Open the hull cover.
3. Adhere included loop tape or velcro tape to the battery.
4. Secure the boat battery on the hook strip in the boat.
5. Secure the battery in the hull with the hook and loop strap as shown.

Check Radio System

Caution: Always keep all body parts, hair and dangling or loose items away from a spinng
propeller, as these can be entangled.
Notice: Always power on transmitter before ESC. Always power off ESC before transmitter.
Never transport the boat with the battery connected to the ESC
1. Turn the transmitter throttle and rudder trim to the middle position.
2. Power on the transmitter.
3. Connect a fully charged battery to the ESC.
4. Ensure the rudder moves in the proper direction when the controller is moved left or right.
5. Pull the throttle to max power position, then return to min power position, ensuring the
propeller turn counterclockwise. The ESC auto-sensing voltage cutoff function will engage
when the ESC detects a low battery charge. Release the throttle and recharge the battery
when necessary.
Notice: Read completely the radio manual for more detailed instruction of using the radio.
Make sure you have totally studied the radio manual before you really start operating the boat
with it.

Getting Started

1. Power on the transmitter.
2. Connect a fully charged battery.
3. Test the transmitter`s control of the boat with the boat on the display stand.
4. After launching the boat in the water, start driving slowly. If the boat does not go straight,
adjust the trimmer on the transmitter to run it straight.
5. Power off the ESC and disconnect the battery packs.
6. Always turn off transmitter at last.
7. Allow the motor, ESC and battery packs to cool before charging the battery or operating
the boat again.
Warning: Always disconnect the receiver battery before turning off the transmitter.
Notice: Always store the boat with hatch removed to prevent mold and mildew growth inside
the hull.
www.modster.at 27