Replacing The Rupture Disk - Loctite Rc18 Bedienungsanleitung

7 Troubleshooting
7.2

Replacing the Rupture Disk

Notice
When the maximum allowable air supply pressure is exceeded, the bursting of the
rupture disc depressurizes the reservoir. The punctured rupture disc must be replaced.
• Disconnect electrical power.
• Loosen the reservoir knob 2 and remove
the reservoir lid 1.
• Remove the screws and open the
housing.
• Remove the rupture disc screw.
• Replace the punctured rupture disc with
a new one.
• Replace and tighten the rupture disc
screw.
Caution!
Tightening torque: maximum 20 Nm.
Affix the supplied type plate.
• Close the housing. Insert and tighten the screws.
16