Specifications - Makita BUC250 Betriebsanleitung

ENGLISH
(Original instructions)
1 Red part
2 Button
3 Battery cartridge
4 Lock-off button
5 Switch trigger
6 Front hand guard
7 Lock
8 Unlock
9 Adjusting screw
10 Carabiner
(rope attachment point)
11 Slightly slide
12 Move in the upright position
13 Press in
14 Loosen

SPECIFICATIONS

Chain speed per minute
Length of guide bar
Guide bar type
Saw chain
Number of teeth
Overall length
Net weight
Rated voltage
• Weight, with battery cartridge, according to EPTA-Pro-
cedure 01/2003
Intended use
The tool is intended for cutting lumbers and logs.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future reference.
CORDLESS CHAIN SAW SAFETY WARNINGS:
1. Keep all parts of the body away from the saw
chain when the chain saw is operating. Before
you start the chain saw, make sure the saw chain
is not contacting anything. A moment of inatten-
tion while operating chain saws may cause entan-
glement of your clothing or body with the saw chain.
Explanation of general view
15 Sprocket cover
16 Adjusting dial
17 Sprocket
18 Adjusting pin
19 Small hole
20 Tighten
21 Lever
22 Low
23 High
24 Guide bar
25 Saw chain
26 Oil tank cap
27 Oil tank opening
28 Oil inspection window
(for refilling the tank with oil)
Model
Type
Pitch
No. of drive links
Sprocket nose bar
91VG
3/8"
40
6
576 mm
2. Always hold the chain saw with your right hand
on the rear handle and your left hand on the
front handle. Holding the chain saw with a reversed
ENE031-1
hand configuration increases the risk of personal
injury and should never be done.
3. Hold the power tool by insulated gripping sur-
faces only, because the saw chain may contact
GEA010-1
hidden wiring. Saw chains contacting a "live" wire
may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
4. Wear safety glasses and hearing protection. Fur-
ther protective equipment for head, hands, legs
and feet is recommended. Adequate protective
clothing will reduce personal injury by flying debris
or accidental contact with the saw chain.
GEB071-5
5. Before starting work, check that the chain saw is in
proper working order and that its condition complies
with the safety regulations. Check in particular that:
• The chain brake is working properly;
• The run-down brake is working properly;
• The bar and the sprocket cover are fitted cor-
rectly;
• The chain has been sharpened and tensioned in
accordance with the regulations;
6. Do not operate a chain saw in a tree. Operation of
a chain saw while up in a tree may result in personal
injury.
29 Oil inspection window
30 Lower guide
31 Felling area
32 Felling direction
33 Danger zone
34 Escape route
35 Scabbard (chain cover)
36 File forward stroke
37 1/5 of the file diameter
38 Small dust or particles
39 Slotted bit screwdriver
40 Locking ring
41 Limit mark
42 Brush holder cap
43 Screwdriver
BUC250
8.3 m/s (500 m/min)
250 mm
Carving bar
25AP
589 mm
4.5 kg
D.C. 36 V
1/4"
60
9
15