ELPRO ECOLOG-NET LP4 Betriebsanleitung Seite 27

3.2.4 elproLOG ANALYZE
3.2.5 elproLOG MONITOR
3.2.6 Installation verification
4. Addendum to elproLOG manual
4.1 Datalogger setup
Window "Datalogger Setup" is used to define the measuring parameters.
...P4 ...H2
x x Log Mode
x x Log Start
x x Log Interval
x x Module Tag
x x Zoom Preset
x x Sensors
x PIN
4.2 Extended Setup
...P4 ...H2
x Low point calibration...
x High point calibration...
x x Direct calibration by values...
x x Define alarm parameters...
x x Reset alarm
x x Set date and time...
x x Logger Display...
x Configure communication settings...
x Terminal mode parameters...
x Set language...
x Select printer...
x x Set temperature unit...
x Set mean value measurement parameter...
x Set new password...
x x Programming of battery change time
a) For a detailed description see elproLOG ANALYZE Operation Manual (SE3003D) or the online help
of the software
D-EL-6003Bk
Manual
ECOLOG-NET
Set the datalogger parameters
This program is used for on-line display of measured values.
Refer to the instruction manual for a detailed description for the
functions and applications
Check the installation and make sure that sensor positions, alarm
parameters and network address are correct. To help, use auxiliary
devices (e.g. calibration connector) in order to simulate defined
measured values.
a)
Use these 3 functions to calibrate the datalogger
Chapter 5
Use to acknowledge and reset an alarm message.
Use to adjust the built-in datalogger clock.
Chapter 2.7
No function in this version
No function in this version
No function in this version
No function in this version
Use to select the used unit of temperature.
You can choose between °C and °F.
Use to suppress line frequency interference.
Use to restart the datalogger after battery replacement
( Chapter 2).
SM3001E.
Seite - 27
11. 2009 AG