Caretero RINGO Bedienungsanleitung Seite 16

2
3
4
REAR AXLE INSTALLATION
Install the rear axle as shown in the
picture. Secure the axle by
screwing the covers with 4 bolts
Ø4x16. Use a screwdriver for this.
Do the same with the second cap.
REAR WHEEL INSTALLATION
As shown in the picture, put the
motor, wheel, washer and nut on
the rear axle in the correct order.
Pay attention to the right and left
engine. Then pull the wheel to
make sure the installation is
correct. Install the hubcap. On the
other side, do as above.
Check that the wheel turns freely. If
the gap between the thread and
the rim is too great, two or three
washers should be added.
Conversely, if the wheel is
tightened too much, it can damage
the engine.
FRONT BUMPER INSTALLATION
As shown in the picture, put the
brackets on the front bumper on
both sides. Place the bumper in
front of the vehicle. Secure the
bumper with four Ø4x12 screws
(2 on one side).
16