Eibenstock EBM 352/3 Originalbetriebsanleitung Seite 24

Using the Drilling Unit
In order to operate safely, please observe the following instructions:
Safety at work:
Make sure that your work place is free of anything that might disturb

your work.
Pay attention that your work-place is well-lit.

Make sure that you observe the conditions for the connection with the

power supply.
When laying the cables, make sure that it cannot be damaged by the

tool.
Make sure that you always can overlook the work place in a sufficient

way and that you always can reach all necessary control elements
and safety devices.
In order to avoid accidents, keep other persons away from your work

place.
Required space for operation and maintenance
If possible, make sure that you have enough free space for operation and
maintenance around the machine (about 2 metres). This way, you can work
safely and in case of operating trouble you can intervene immediately.
When you drill into blocs, make sure that the blocs are well anchored

and fixed.
Before drilling in supporting parts, make sure that you do not

disregard the statics. Observe the instructions of the experts who are
responsible for the design.
Make sure that you do not damage any gas mains, water mains or

electric cables while drilling.
Pay attention that you do not touch any metallic parts of the machine

when you drill walls and grounds where electric cables could lie under
water.
Pay attention that the drilling core does not hurt anybody or damaging

anything when it drops out.
If the drilling core might cause any damage when it drops out, use an

device that can hold back the drilling core.
Make sure that the drill bit is well fixed.

Only use tools which are suitable for the particular material.

Preparation
24