Herunterladen Inhalt Inhalt Diese Seite drucken

Electrolux EWF 146310 W Benutzerinformation Seite 24

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

24 electrolux
Water inlet
An inlet hose is supplied and can been
found inside the machine drum. Do not use
the hose from your previous machine to
connect to the water supply.
Important! This appliance must be con-
nected to a cold water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine. Do not place
the inlet hose downwards. Angle the
hose to the left or right depending on
the position of your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
All manuals and user guides at all-guides.com
4. Connect the hose to a tap with a 3/4"
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Water-stop device
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window «A» . Should this occur, turn
the water tap off and refer to your Service
Centre to replace the hose.
Water drainage
The end of the drain hose can be posi-
tioned in three ways.
• Hooked over the edge of a sink using
thread. Always use the hose supplied
with the appliance.
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the ma-
chine is emptying. This could be done by
A

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis