Electrolux EWF 146310 W Benutzerinformation Seite 10

10 electrolux
For the compatibility among the wash-
ing programmes and the options see
chapter «Washing Programmes».
Select the Delay Start by pressing
button 7
Before you start the programme, if you wish
to delay the start, press the button 7 re-
peatedly, to select the desired delay. The
selected delay time value (up to 20 hours)
will appear on the display a few seconds,
then the duration of the programme will ap-
pear again.
You must select this option after you have
set the programme and before you press
button 6 .
You can cancel or modify the delay time at
any moment, before you press button 6 .
Selecting the delayed start:
1. Select the programme and the required
options.
2. Select the delay start by pressing the
button 7 .
3. Press button 6 :
– the machine starts its hourly count-
down.
– The programme will start after the se-
lected delay has expired.
Cancelling the delayed start after having
pressed button 6 :
1. Set the washing machine to PAUSE by
pressing button 6 .
2. Press button 7 once until the value
is displayed
3. Press button 6 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start can not be selected with
the DRAIN programme.
Start the programme by pressing
button 6
To start the selected programme, press the
button 6 , the corresponding green pilot
light stops blinking. The pilot lights 8.1 and
8.2 illuminate to indicate that the appliance
starts operating and the door is locked.
To interrupt a programme which is running,
press the button 6 : the corresponding
green pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 6
All manuals and user guides at all-guides.com
again . If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 6 blinks for 3 times
the message Err is displayed for a few sec-
onds.
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 6 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
gramme position. Start the new programme
by pressing the button 6 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
'
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 6 . After a
few minutes the light 8.2 goes out and it is
possible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the
door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
few minutes the door can be opened (pay
attention to the water level and temper-
ature!) .
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 6 .
and then to the new pro-
to cancel a pro-
. After a