Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connection
Loosen screws (A) and extract the plug insert manually from the enclosure.
Loosen clamp (C) and pressure screw (B). Remove the dust protection plate, and take
out the pressure ring and seal.
Push the cable (max. 50 mm) through the pressure screw, pressure ring, seal and
enclosure. If necessary, increase the internal diameter of the seal by trimming it to
match the cable diameter.
Strip the insulation from the cable (see figure).
On the connection side, the contact pin carrier is marked with "Abisolation"
(insulation stripped) next to the protective conductor connection symbol. The
indentation below indicates the correct stripping length.
Connect the cable to the plug insert. The stripped cable ends must be pushed fully
underneath the clamping plate.
Align the cable such that the clamping points are not under strain.
Mount the strain relief (D).
Fasten the plug insert in the enclosure such that key and guiding groove (E) match.
Press the seal into the enclosure, with the closed side pointing outward.
Place the pressure ring on the seal.
Tighten the pressure screw (B).
Secure the pressure screw with the clamp (C).
Protective conductor connection
A protective conductor is always required.
153705 / 8581605300
2011-06-18·BA00·III·en·04
A =
Screw
B =
Pressure screw
C =
Clamp
D =
Strain relief
E =
Guiding groove
09192T00
Connection cross-section
a
b
[mm]
[mm]
2
[mm
]
110
36
35 ... 50
09290T00
Plug
8581/12
Installation
7
Werbung
Kapitel
Inhaltsverzeichnis
