Herunterladen Inhalt Inhalt Diese Seite drucken

System Components; Installation; Installation On The Roof - Megasat Caravanman Kompakt Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Caravanman Kompakt:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Introduction

1.4 System components

Open the box and remove the control unit, cables and packing material. Lift the antenna
straight up out of the box. Never place the system upside down. When you lay down the
antenne, make sure that the cable attached to the antenna not be below the base plate
to prevent damages.
Antenna unit
The 45 cm high-gain antenna and the elevation angle of 15-62°
allows optimum reception throughout Europe.
Control unit
The control unit is used for satellite selection and control. It is
connected between the antenna and the set-top box and sup-
plied the antenna with electricity.
Note:
The Caravanman Kompakt Twin also has another connection for a second set-
top box. For the correct connection of the components, refer to the wiring dia-
gram on page 8.
04
Warning:
When you take it out of the box,
you never grip the antenna directly
on the dish. Grip the antenna on
the base plate.
ENGLISH

2. Installation

2.1 Installation on the roof

Basically, we recommend that you leave the installation to do by your dealer or workshop!
Warning: Please also note that the antenna will change the height of the
vehicle will change accordingly! Please strictly adhere to the various points in
the installation instructions!
General Information:
Provide a suitable working environment, a garage/warehouse is better than open air.
The ambient temperature for installation is between +5° C and max. +25° C. Work not
directly in the sun. Comply with the safety regulations when handling with chemical
products. Provide the necessary hygiene.
Preparation:
1. Make sure that the roof of your vehicle is sufficiently stable. In case of insufficient or
doubtful roof stability an approximately 2 mm thick plate with 100 x 100 cm is to be
attached to the outer roof skin. Ask your vehicle manufacturer.
2. Make sure that all parts are present.
3. Place the antenna on the later assembly
area and align it so that the mirror and
the LNB unit pointing towards the rear
of the vehicle. Make sure that the slot
is flat and no roof structures in the way
that can interfere with satellite recepti-
on. Constructions up to 20 cm in height
do not matter, higher ups should have
a corresponding distance to the anten-
na, so that no obstacle exists between
the antenna and the satellite. The least
distance to an air conditioner should be
30 cm.
4. Clean the mounting surface with a
suitable cleaner and a fleece cloth to
remove dirt and impurities. Then draw
the antenna feet with a pen.
ENGLISH
05

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis