System Components; Installation; Connection Of The Components; Control Unit - Megasat Campingman Portable 2 Bedienungsanleitung

1. Introduction

1.4 System Components

Open box and remove the control unit, cables and packing material. Lift the antenna
straight up out of the box. Never place the system upside down!
Antenna unit
The elegant plastic housing will protecting the antenna against outsi-
de weather conditions. Under the housing there is a 38 cm high-per-
formance antenna. The Auto Skew system and the new technology of
0-90 ° elevation enables optimal reception across Europe.

Control unit

The control unit is used for satellite selection and control. It is connec-
ted between the antenna and the set-top box and supplied the antenna
with electricity. After successful alignment, the device can be turned off.
Warning:
The control unit must be operated only on the selected antenna port.
Only this is provided for controlling. The second port is for use of an
additional set-top box or for an twin set-top box.
04
With this metal eyelet, you
can secure the Campingman
Portable 2 against stealing.
DEUTSCH

2. Installation

2.1 Connection of the Components

Install the control unit and the set-top box is not inside the vehicle in the region of an
airbag. Maintain a careful installation of the cable in order to avoid short circuits. Pay
attention also to existing cables.
Connect the antenna as shown in the illustration below:
Campingman Portable 2
12~24 V DC 5 A
or with the optional
power supply
230 V AC / 12 V DC 5A
RED
(+)
( - )
BLACK
Control unit
Information:
The antenna does not need to
operate with two set-top
boxes mandatory!
Television 2
Television 1
ENGLISH
05