Connection Diagrams - Stahl 8562/5 Serie Betriebsanleitung

Commissioning

8.3 Connection diagrams

Schematic
07606E00
1-pole + N
96 98
95
11536E00
Auxiliary contact 1 CO
The device may be connected from the top or the bottom side. It has to be taken care that
the neutral conductor is connected correctly.
9 Commissioning
Before commissioning, ensure that:
the device has been installed in accordance with the standards,
the connections have been correctly made,
the device is not damaged,
all screws and nuts are fully tightened.
10 Servicing
10.1 Maintenance
Maintenance and repair work on the devicess may only be carried out by appropriately
authorized and trained personnel.
Before any work commences, the devices must be disconnected from the supply.
Observe the relevant national regulations in the country of use!
The following items must be checked as part of the maintenance schedule:
Check that no cable connections are loose.
Check the plastic enclosure for cracks or other visible signs of damage.
Check that the permitted temperatures, in accordance with IEC/EN 60079-0, are
adhered to.
Check the reset function of the switch lever.
Check that the device functions correctly.
10
Residual current circuit-breaker with
integral overcurrent protection
8562/5
07621E00
2-pole
06 08
05
07618E00
Fault indication contact 1 CO
98 08
95 05
12218E00
Auxiliary contact 1 NO
Fault indication contact 1 NO
96 98 06 08
95 05
12219E00
Auxiliary contact 1 CO
Fault indication contact 1 CO
149915 / 8562606300
S-BA-8562-03-en-20/11/2008