Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-26
Start-up
If the mains plug is no longer acces-
■
sible after connecting it, an all-pole
disconnecting device complying with
overvoltage category III must be con-
nected into the house wiring with a
contact gap of at least 3 mm; consult
a qualifi ed professional if necessary
(see "Service" on page EN-32).
Do not kink or pinch the mains cable
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
Connect the appliance only to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
If possible, do not tilt the cooling ap-
■
pliance horizontally.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
Insert the mains plug into an easily accessible
and properly installed socket (220–240 V~ /
50 Hz).
You will find all important information
about operation from page EN-12.
Werbung
Kapitel
Inhaltsverzeichnis
